A must-have device that will be found in a corner of virtually every home is an inverter. Even schools, offices or public buildings are not exempt from this rule. When it comes to pushing, these rectangular contraptions save the day. When there is a power outage, as it inevitably happens, it is the inverter that provides backup electricity. The gist: The value of inverter batteries cannot be emphasized enough.

Now imagine a scenario. A home has the best of the best inverter installed from one of APC ups preferred dealers. A few months later, there is a shortage of electricity. What follows next is shocking. Instead of serving as a backup, the inverter does not work. There is no power to charge a mobile or run the fan or even turn on the light.

Unfortunately, this situation is relatively common. Like any other appliance installed in a residence, inverters are prone to failure. Fortunately, there are some problems that can be fixed at home. Solutions to the most common battery problems are addressed below.

  • The inverter does not turn on

The causes of an inverter not turning on are multiple:

  1. inverter tripped
  2. battery disconnected
  3. weak battery
  4. Low battery
  5. loose terminals
  6. reverse terminals
  7. faulty switch

For each problem, there is a different output. A tripped inverter can be resolved by pressing the reset button on the device. If the power switch is causing a problem, have it repaired at a service center. In the event that the battery is faulty or faulty, it will need to be replaced. For weak batteries, the best answer is to let it charge for a few hours, but if it is old, the best option is to buy a new one. For a terminal complication, inspect for corrosion, clean off the rust, then clamp them securely.

  • Constant beeping alarm

When the inverter bears too much load, it starts to sound the alarm. The only way to stop the beeping is to unplug all devices that are causing additional load on the inverter. Another reason the alarm may sound is when the cooling fan is stuck. The fan is necessary to maintain a cool temperature in the system while the inverter is running. If for some reason the fan does not work, the inverter will shut down or the alarm will sound.

The beeping indicates that the unit is not operating safely and should be turned off. The key is to clean the fan and get it working again. If none of the strategies solve the problem, take the inverter to a service center.

  • LCD shows wrong codes

A common problem with power inverters that have LCD displays is false codes. The numbers displayed may be incorrect due to:

  1. external problem
  2. internal problem

Internal problems are usually circuit related and can only be resolved by a qualified professional. The external complication can be resolved by:

  1. Battery Cable Inspection
  2. Checking the output or input cables
  3. Load Recheck
  • Low backup capacity

The only typical concern of investors is a very short backup time. The causes leading to this problem can run the gamut:

  1. Too much energy consumption: to solve, eradicate any additional load
  2. Improperly charged battery: To correct, charge it continuously for a few hours.
  3. Low Electrolyte Level – To resolve, refill the water using only distilled water to the recommended level. Always keep it somewhere in between the minimum and maximum limit.
  • The battery refuses to charge

One problem that some inverters face is that they do not charge the battery. This happens when:

  1. The battery is dead
  2. rectifiers burn out
  3. The fuses have melted
  4. connections are loose

The first problem can only be solved by replacing the battery. The solution to the other three is to clean the terminals for corrosion. If nothing works, licensed help will be required.

  • Sounds inside the inverter

A difficulty that several inverters have is the noise that comes from inside them. The vital point to note is that every power inverter emits certain sounds. it’s standard. But sometimes the cooling fan collects a lot of dust and debris causing strange noises and tinkling noises. Clean the fan. You have to take care of the sound. If noise persists, replace fan.

The gist – Be practical

There was a time when inverters were a luxury item few could afford. Today’s environment of frequent power outages is no longer conducive to this thinking. Any place that houses people needs a backup and a bright inverter are excellent options. Knowing how to fix the small faults that occur in every appliance can save you a lot of headaches. Get hands-on, learn how to solve small investor-related problems, and save money, effort, and time hiring professionals.

Leave a Reply

Your email address will not be published. Required fields are marked *